To enable auto close switch dip-switch 6 onĭipswitch 4 – Program Predestrian opening. When the gate is closed, switch dipswitch 3 off again.Press the Program button again and release – The gate will close.Count the time you want the gate to stay open.Press program button and release – the gate will open and the BIG RED LED will start flashing.Can be programmed from 2 to 255 seconds.When it is done, move dip-switch 2 to the off position.The gate will open and close slowly to find limits, then second time around will go faster.Now press the remote or bridge the 0V and Trigger terminals then release.Press program button – wait for the BIG RED LED to switch on and stay on, then release the program button.Gate closes to the right – dip-switch 1 onĭipswitch 2 – Gate Programming / Setting the Limits.Gate closes to the left – dip-switch 1 off.NB! NB! Make sure the 12V wire coming from the second battery is connected to terminal.Restore dipswitches to original positions (1 is gate closing direction, 6 is autoclose for gates with IR beams.Check Battery power when gate is running (Must be 24 Volts or more.Check Battery power (Must be 24 Volts or more.Disengage the gate, Check That the gate moves freely and that there are no obstructions.Before any wiring is done, take power switch off and disconnect power! Step 1 – Basic checks
0 Comments
Leave a Reply. |